Maintenances of Noodle Making Machines

- May 29, 2020-

1. The panel cannot be connected normally?


Due to improper adjustment of the roll gap, there will be broken plates and residual plates. For example, the previous panel is thin, the next panel is thick, and the next demand is large. In this way, the plate will be broken. Otherwise, the residual plate will be adjusted by this reason. When boarding, reduce the gap between the next pair of rollers to make it even.


2. Is the panel running or uneven on both sides of the panel?


Is caused by the inconsistency of the gap between the two ends of the roller, so adjust the gap between the two ends of the roll to make it even.


3. The panel and noodles are curved?


The installation angle between the scraper and cutter comb between the rolls is too large or the blade edge of the comb is reversed, and it can be adjusted in place.


4. The panel is covered with rolls?


It is because the surface has too much moisture or the blade bolt is loose.


5. Can't break noodles?


The cutting edge of the cutting edge does not match the bottom plate. The cutting edge of the cutting edge can be adjusted to the right position.


6. Broken noodles?


It is because there are impurities in the flour (residues left in the noodle barrel last time) or uneven noodles.

50f048a9-6ad5-40da-a504-44300041aa74_看图王4